Services
Heating, cooling and wiring, in one plan.
Every job starts with the same assessment and ends with the same written plan. These are the pieces.
Heat pumps
Ducted systems that heat and cool the whole house from one outdoor unit. We test the ducts and size the system from a load calculation.
Heat pumpsReplaces a furnace and air conditioner together
Ducts tested before they're reused
Electrical work included in the plan
Mini-splits
Ductless indoor heads for rooms, additions and houses with no usable ducts, each connected to its own outdoor unit.
Mini-splitsOne head or several zones
Wall or ceiling units
Condensate and line sets planned
Panels and service
A new panel, a subpanel or a service upgrade, sized from a load calculation and permitted.
Panels and serviceLoad calculation first
Utility coordination
Inspection scheduled with you
Circuits and chargers
Dedicated circuits for a range, a dryer, a heat pump water heater and a car charger, so the house is ready before the appliance is.
Circuits and chargersWired now or left capacity for later
Charger location planned with you
Labeled at the panel
Also
Work on equipment that is staying.
Gas furnaces and air conditioners
Service and repair on equipment you're keeping for now, as the schedule allows. We're an install shop first, so a repair call in a heat wave may wait.
Duct testing and sealing
A leakage test, then sealing and insulating the runs we can reach.
Thermostats and controls
Setup that matches how the house is used, explained before we leave.
Start with the assessment.
We walk the house, check the panel and write the plan. You can stop after any step.